Installing An I/O Module (Or I/O Blank) - Adaptec FS4500 Installation & User Manual

!
Caution: Adaptec highly recommends that you power off the
Storage Enclosure before removing or installing any SATA
or FC I/O module.
SCSI I/O modules are not hot-swappable.
2 Disconnect all the cables connected to the I/O module.
3 Loosen the two screws below the I/O module handles.
4 Gently push down on the handles
to disengage the I/O module from
the enclosure.
5 Using the handles, gently slide the
I/O module out of the enclosure
(shown at right).

Installing an I/O Module (or I/O Blank)

1 Power off the host system and enclosure.
!
Caution: I/O modules are not hot-swappable. You must
power off the host system and enclosure before installing
an I/O module or I/O blank.
2 Ensure that the handles of the new I/O module are lowered
(open).
Note: Do not use the handles to lift or carry the I/O module.
3 Gently push up on both handles simultaneously to fix the I/O
module into place.
4 Secure the module by tightening the two screws you loosened
in Step 3 on page
tighten them.
5 Connect the I/O cables, as described in the chapter of this Guide
that is dedicated to your specific Storage Enclosure's interface:
Removing and Replacing Enclosure Components
4-8. Hand-tighten the screws. Do not over-
4-8