Installing into a Rack
Begin the installation by ensuring that you have all these rail kit
components:
Front rails (1 left, 1 right)
■
Rear rails, two different sizes (2 left, 2 right)
■
Two sizes of screws (10 large, 4 small)
■
Two types of nuts (10 of each)
■
To install your Storage Enclosure in a rack:
1 Secure the front rails to the front supports of the rack, using the
supplied screws, as shown in
Note: Use either the speednuts or cagenuts provided if
your rack does not have threaded holes.
Figure 2-1 Securing the Rails to the Rack
2 Check the length between the front and rear supports of your
equipment rack and determine which set of rear rails to use, the
long or the short.
Installing the Storage Enclosure
Figure
2-1.
2-4