Storing Components - Dell EMC VEP4600 Installation Manual

Hide thumbs Also See for EMC VEP4600:

Table of Contents

● Short push:

○ Sends ACPI power event to the Operating System (OS.)

NOTE:

Response depends on configuration of how the OS is booted-up when it receives a ACPI power event. The

response may ignore the button push or shutdown the system.

● Long push:

○ Sends ACPI power event to the OS and immediately puts the CPU to sleep. When CPU is in sleep state, a short push

brings the CPU out of sleep and reboots the system.

CAUTION:

Always turn off the processor correctly. Hold the ACPI on/off button down for five seconds to

boot-up after a correct processor shutdown.

NOTE:

Before you unplug the platform power cable, either turn off the processor using the software console or hold the

ACPI on/off button down for five seconds.

Storing components

If you do not install your VEP4600 and components immediately, properly store the platform and all optional components using

these guidelines:

● Storage location temperature must remain constant. The storage range is from -40°C to 70°C (-40°F to 158°F).

● Store on a dry surface or floor, away from direct sunlight, heat, and air conditioning ducts.

● Store in a dust-free environment.

NOTE:

ESD damage can occur when components are mishandled. Always wear an ESD-preventive wrist or heel ground

strap when handling the VEP4600 and accessories. After you remove the original packaging, place the VEP4600 and

components on an anti-static surface.

Site preparations

Table of Contents