Table of Contents
Advertisement
10. As for mounting bracket to incorporate this product into an equipment,
(1) When this product is incorporated into an equipment by using the mounting screw hole in the right
and left side planes, the clearance between this product and the mounting bracket is too wide;
(2) When this product is incorporated into an equipment by using the screw hole mounting in the bottom,
the surface of the mounting bracket is contorted.
If you use such mounting bracket as the above, this product will become deformed, which may cause
operation failure. Therefore, it is necessary to take account of the mounting bracket which has the
tolerances shown in Fig.1 or whose structure cannot cause this product to deform, as shown in Fig.2
11. In the instruction manual of your product, statement described in "Safety Instruction Manual "attached
to this product, the statement of item 2 ,7 and 9 above, and other required statements should be
mentioned for thorough understanding by the users.
+ 0.2
146.3
- 0
Fig.1
before the fixing
Fig.2
146 +/ - 0.3
this product
mounting bracket
Flatness:less than 0.5mm
this product
after the fixing
XM-6401B Rev.1.0
Advertisement
Table of Contents
