Rvp-Tda3X Adas Development Kit And Rvp-Dm50X Development Kit: Surroundview - D3 DesignCore RVP-TDA3 Series Quick Start Manual

4.2 RVP-TDA3x ADAS Development Kit and RVP-DM50x Development Kit: SurroundView

Note: Images shown are of RVP-TDA3x ADAS Development Kit.
1. To prepare the RVP-TDA3x ADAS Development Kit, first attach the two provided axle
assemblies, 1000396. Screw them in to the main platform with the provided M5x14 bolts
and M5 nuts. Align the axle assemblies with the pre-drilled holes in the plate and bolt the
axles so that the angle faces inward, as shown below.
a) Front axle assembly, facing inward
toward center of plate
b) Rear axle, facing center of plate
c) Top side of screw in plate holding axle
d) Bottom side of plate with nut holding
axle to plate
2. Next, if the cameras aren't already mounted to the development plate, attach them using
the provided mounting hardware, as shown below. This hardware may differ depending
on which cameras come with the kit.
DesignCore™ TDA3x Product Family ▪ Quick Start Guide
Document No. 00C-131 ▪ Version 1.0 ▪ Release Date: 1/17/2019
- 13 -
CONFIDENTIAL ▪ 13
D3Engineering.com ▪ 585.429.1550
www.d3engineering.com 585.429.1550