Troubleshooting - TdA L200Y User Manual

L200Y SLIDING GATE OPERATOR USER'S MANUAL

9. Troubleshooting

Trouble
Motor only runs in one direction.
By pressing button 1(button 2 or button
3) which has been programmed to
open the gate, press the same button
again to stop the gate in required
position, but the gate will auto-close
immediately.
When you use button 4 of remote
control to open the gate, gate travels
too short.
When you use button 4 of remote
control to open the gate, but the gate
will auto-close immediately.
The gate will not open or close.
Remote control does not work
When you open the gate by using
button 1(button 2 or button 3) which
has been programmed, gate will stop in
mid-travel or reverse before reaching
the fully limit position.
The remote control operating distance
is too short.
Table 4
Possible causes
The wire connector terminal block becomes
loose.
The limit switch wire connector terminal block
becomes loose.
The auto-close time is too short.
The width of pedestrian mode is too narrow.
The auto-close time of pedestrian mode is
too short.
The limit switch wire connector terminal block
becomes loose.
Connecting wires or terminal blocks are too
loose.
The electric component on the control board
such as Q6 may be damaged.
Power switch is OFF
The indicator light of remote control does not
light.
Remote control is not suitable for receiver.
Broken receive board
The Force Adj. (VR) is adjusted too small.
Gate is obstructed.
Signals are shielded by the gate.
16
Solutions
Check wire connector terminal block.
Check limit switch wire connector terminal
block.
Check the limit switch mode.
Reset the auto-close
auto-close function section.
Reset the width of pedestrian mode. See Set
width of pedestrian mode section.
Reset the auto-close time of pedestrian. See
Set auto-close function of pedestrian
mode section.
Check the limit switch mode (see table 2
DIP-switch).
Check the connecting wires and terminal
blocks.
Replace the electric component Q6 or
replace the board.
Make sure power switch is ON.
Check the batteries on your remote control
After making sure the codes are correct,
erase remote controls and then re-program
the codes in the device. See Adding extra
remote controls (learning) section.
Replace receive board.
Check the Force Adj. (VR). Adjust VR to
increase force.
Remove the obstruction.
Link a new antenna (1~1.2m BVR 0.75mm
to the old antenna. Then fix the antenna on
the wall vertically, make sure the total height
from the top of antenna to the ground is
approx. 1.5m.
time. See Set
2
)