Sensors; Unbalanced Load Detection System; Cleaning And Maintenance - Siemens WN34A1L0DN Instruction Manual And Installation Instructions

Activate setting mode:
Set the programme selector to
1.
position 1. The appliance is switched
on.
Touch and hold the 0 (Spin speed)
2.
button and, at the same time, turn
the programme selector clockwise to
position 2. Release the 0 (Spin
speed) button.
The setting mode is activated and the
preset setting appears in the display
panel.
Changing the volume and drum care
information
Use the B (Finished in / Time Dry)
button to change the following settings
at the corresponding programme
selector positions:
2: The volume of the end signal.
■
3: The volume of the button signals.
■
0 = off, 1 = quiet,
2 = medium, 3 = loud,
4 = very loud
4: Switching the drum care
■
information signal on/off.
on
Ž
Πoff
Exiting setting mode
You can now end the process and set
the programme selector to the Û (Off)
position. The settings are saved.
H

Sensors

U nbalanced load detection
S e n s o r s
system
The automatic unbalanced load
detection system detects imbalances
and ensures even distribution of the
laundry by repeatedly starting and
stopping drum spinning.
If the laundry is extremely unevenly
distributed, the spin speed is reduced
or the spin cycle is not performed for
safety reasons.
Place large and small items of
Note:
laundry evenly in the drum.
2
Cleaning and
maintenance
:
Warning
C l e a n i n g a n d m a i n t e n a n c e
Risk of death!
There is a risk of electric shock if touch
live components.
Turn the programme selector to Û (Off).
Pull out the mains plug.
Caution!
Fire and explosion hazard!
Toxic vapours can be produced by
cleaning agents that contain solvents,
e.g. cleaning solvent.
Do not use cleaning agents that contain
solvents.
Caution!
The appliance may be damaged!
Cleaning agents that contain solvents,
e.g. cleaning solvent, can damage
surfaces and components in the
appliance.
Do not use cleaning agents that contain
solvents.
Sensors
en
41