Table of Contents
Advertisement
Cleaning and maintenance
en
Refit and screw on the pump cover.
5.
The handle must be in a vertical
position.
Close the service flap.
6.
To prevent unused detergent
Note:
from flowing straight into the drain
during the next wash: Pour 1 litre of
water into dispenser II and start the
Drain programme.
The drain hose at the siphon
is blocked
Turn the programme selector to Û
1.
(Off). Pull out the mains plug.
Loosen the hose clamp. Carefully
2.
remove the drain hose; residual
water may leak out.
Clean the drain hose and siphon
3.
connecting piece.
44
Re-attach the drain hose and secure
4.
the connection point using the hose
clamp.
Filter in the water supply is
blocked
Release water pressure in the supply
hose:
Turn off the water tap.
1.
Select any programme (except
2.
Rinse, Spin, Drain programmes).
Select the I (Start/Reload)
3.
button. Allow the programme to run
for approx. 40 seconds.
Turn the programme selector to Û
4.
(Off).
Pull out the mains plug.
5.
Clean the filters:
Disconnect the hose from the rear of
1.
the appliance.
Use pliers to remove the filter.
2.
Advertisement
Table of Contents
