Yamato TC 350/13 Instruction Manual page 20

GB
Maintain tools with care
Keep cutting tools sharp and clean for better and safer
performance.
Follow the instructions for lubricating and changing accessories.
Keep handles dry, clean and free from oil and grease.
Ensure that ventilation slots are kept clean and free from dust
at all times. Blocked ventilation slots can cause overheating and
damage to the motor.
If this machine is to be used when working at a certain height,
scaffolding fitted with railing and kick-plate or a tower platform
must be used in order to guarantee suitable stability.
GUARD AGAINST ELECTRIC SHOCK
Avoid body contact with earthed or grounded surfaces (e.g.
pipes, radiators, dish-washers and refrigerators).
Power Cords
Never yank or pull the power cord to disconnect it from the
mains supply socket.
Never carry the power tool by its power cord. Keep the power
cord away from heat, oil, solvents and sharp edges.
Check the tool power cord periodically and if damaged have it
replaced by an authorized service center.
Inspect extension cords periodically and replace if damaged.
DO NOT use 2-core extension cords or reels on power tools
with an earth path. Always use a 3-core extension cord or reel
with the earth core connected to earth.
Always unwind any extension cords fully.
For extension cords up to 15 metres, use a wire cross section
of 1.5mm .
2
For extension cords over 15 metres, use a wire cross section
of 2.5mm .
2
Protect your extension cord from sharp objects, excessive heat
and damp or wet locations.
This power tool complies with National and International
Standards and safety requirements. Repairs should be
carried only out by qualified persons using original spare
parts. Failure to do so may result in considerable danger
to the use.
20