VADDIO 999-1701-100 Installation And User Manual page 5

AutoVIEW IR Sensor Kit
The AutoVIEW IR Control Interface:
The AutoVIEW IR (AIR Box) Control interface supplies power the IR Senor and returns a closure pair (short to
ground) to the TRIGGER OUT which can be connected into any Vaddio or other device with a trigger input.
The plastic box for the control interface is approximately 3" (76.2mm) W x 2" (50.8mm) H x 1" (25.4mm) D and
have the following attributes:
AutoVIEW IR (AIR) Control Interface Top View
2- Pin
Phoenix
Connector
Trigger
Out
Basic System Configuration
Single IR Sensor Detects Presenter within the IR Zone and provides a trigger output to the AutoPresenter to
change the camera and PTZ position preset.
Vaddio HD-20 HD Cameras
Control &
HD Video
AutoPresenter
Also works with:
 ControlVIEW XHD
 Hot-Shot Camera Preset Controller for
Select Polycom, LifeSize and
Cisco/Tandberg Codecs
 ProductionVIEW Series Seamless Switcher
and Controllers
 Any control system that can accept a short
to ground trigger
AutoVIEW IR Sensor Kit Manual 341-233-1 Rev. C
2- Pin
Trigger
Out
Cat-5e
To IR
Sensor
18VDC
Power Input
Trigger OUT
to Trigger IN
2-wires
AutoVIEW IR (AIR) Control Interface ISO View
18VDC
Power
Input
AutoVIEW
IR Sensor
AutoVIEW IR Air
Box IR Control
Interface
Contact Closure
Power
RJ-45 Jack
Cat-5e to IR
Sensor
Single Cat-5e
Cable - Up to 100
(30.48m)
Page 5 of 8