Vacmaster VBV1330PF Operator's Manual page 13

1. Verify that the power cord is disconnected from the outlet. (fig. 1)
2. Remove power head and place in upside down position. Follow instructions to remove
cloth filter.
3. Carefully slide foam sleeve filter down over the filter cage making sure the whole cage is
covered. (fig.2 & 3)
4. Replace the power head on to the container.
Cleaning Foam Sleeve Filter
1. With the removed power head in the upside down position, carefully remove foam sleeve
filter. (fig. 4)
2. Use a mild soap and water solution to wash foam sleeve filter and rinse with clean water.
(fig. 5)
3. Allow filter to air dry before installing and using again.
TROUBLESHOOTING
WARNING! TO REDUCE THE RISK OF ELECTRIC SHOCK-UNPLUG BEFORE
TROUBLESHOOTING
Symptom
Vacuum will not operate
Dust comes out from motor
cover.
Reduced efficiency and
motor/speed vibration.
Possible
Causes
1) No power
supply.
2) Faulty power
cord.
3) Container
full.
1) The cartridge
filter is missing or
damaged.
1) There is a
blockage in the
nozzle, hose, or
the container
inlet. The
cartridge filter is
clogged by fine
dust.
12
Corrective Action
1) Check power supply – cord,
breakers, fuses.
2) Unplug and check the power
cord. If damaged, have it repaired
by a professional.
3) Empty container.
1) Attach or replace cartridge
filter.
1) Check nozzle, hose and
container inlets for blockage. Take
off the filter and clean it. Or install a
new cartridge filter.