GE HGP6070E Use & Care Manual page 44

You can choose between three types of py-
rolysis for cleaning.
Pyro Turbo. The cleaning process takes 2
hours.
Note: Pyrolysis cleaning is possible with
this option, with the enamelled tray ac-
cessory. Place it at level 2. First remove
the excess grease accumulated.
Pyro Eco. The cleaning process takes one
and- a-half hours.
Auto Pyro. The duration depends on how
dirty the oven is.
To activate it, switch on the oven by pressing
, then press repeatedly to select the de-
sired cleaning mode. Validate by pressing
(3.4.1). The pyrolysis will begin immediately.
Note: Time and temperature parameters for
pyrolysis cannot be modified.
When the process begins, the
oven reaches very high tem-
peratures, the door safety
lock is activated and ap-
pears on the display (3.4.2).
When the oven has cooled
down, the symbol disap-
pears and the door can be
opened.
3.5 Delayed pyrolysis.
You can set the pyrolysis end time. Press
to switch on the oven and then press
select the most suitable pyrolysis mode
(3.5.1). Press . The symbol
the display. Enter the cleaning end time by
pressing and . Validate by pressing
(3.5.2).
44
3.6 Cleaning the inside walls. Take out the
side runners and clean off any grease or ash
that has been left after the cleaning pro-
cesses.
Depending on the model, the side runners
are fixed in two ways, either without a sup-
port (3.6.1, 3.6.2) or with a support (3.6.3,
3.6.4). When you have removed them, use a
damp cloth to clean the side walls (3.6.5).
When you have cleaned the oven walls, re-
place the runners.
If your oven has a fold-down grill, pull up-
wards and press to fold it down (3.6.6) and
clean the top wall with a damp cloth (3.6.7).
3.7 Cleaning the glass
Cleaning the outside of the glass: Use a soft
cloth soaked in a glass cleaning product.
Cleaning the inside of the glass: If the inside
of the glass is dirty, you can remove it for
cleaning.
When the oven has cooled down, open the
door as far as it will go (3.7.1) and fix it in
place with the red stops supplied in the ac-
cessory bag (3.7.2). Insert the two remaining
accessories so that they provide leverage to
lift up the glass (3.7.3). Remove the glass
(3.7.4), clean it and dry it with a cloth (3.7.5).
If necessary, remove the whole glass panel
unit inside the door. This unit consists of ei-
ther one or two glass panels, depending on
the model, with a black stop in each corner.
To remove them, place your hand under the
door and pull upwards (3.7.6). When you
have taken out the unit, remove the stops to
clean the glass panels (3.7.7).
When glass panels are clean (3.7.8) fit them
onto the rubber stops again, with the stud
to
facing upwards (3.7.9) and replace the glass
panels so that the letters "L" (left) and "R"
will appear on
(right) are beside the hinges (3.7.10).
Finally, place the remaining glass panel so
that the word PYROLYTIC can be read (3.7.11).
Remove the stops (3.7.12) and close the door.