adjusting the rinse aid setting
The rinse aid reservoir has five settings. Both the recommended setting and the factory setting is
"4." If the dishes are not drying properly or are spotted, adjust to the next higher number until your
dishes are spot-free. If you fine they are spotted with rinse aid when the cycle has finished the
reduce the level.
1. With the dishwasher switched off press and hold the P
button.
2. While holding the P button down press the Power button to
switch the dishwasher on.
3. Keep holding the P button down until you see 'rA' in the
display. Then the display will show the current rinse aid
setting. The factory setting is r4.
4. Press the P button to scroll through the levels.
5. To save the setting press the Power button.
rinse aid
rinse aid
level
No rinse aid
1
released
1 dose is
2
dispensed
2 doses are
3
dispensed
3 doses are
4
dispensed
4 doses are
5
dispensed
Kenwood Integrated Diswasher KID60S18 Manual.indd 21
Switch on while
holding button P down
dose
Press and hold
Switch on while
holding button P down
rinse aid level indicator
KID60S18
21
07/12/2018 12:17