Table of Contents
Advertisement
5
Enter the desired name. a MOKN
6
Enter the desired number. a MOKN 2
times
R "Baby Monitor" will be displayed.
Note:
R The registered name/number is displayed.
Turning off the baby monitor
The monitored handset cannot be used while
baby monitor is set to "On".
1
Press MMENUN on the handset being
monitored.
2
MbN: "On/Off" a MOKN
3
MbN: "Off" a MOKN a M
Editing an outside monitoring number
1
Press MMENUN on the handset being
monitored.
2
MbN: "On/Off" a MOKN
3
MbN: "On" a MOKN
4
MbN: Select the outside line. a MEDITN
5
MMENUN a MbN: "Edit" a MOKN
6
Edit the name if necessary. a MOKN
7
Edit the phone number if necessary. a
MOKN 2 times
Erasing an outside monitoring
number
1
Press MMENUN on the handset being
monitored.
2
MbN: "On/Off" a MOKN
3
MbN: "On" a MOKN
4
MbN: Select the outside line. a MEDITN
5
MMENUN a MbN: "Erase" a MOKN
6
MbN: "Yes" a MOKN a M
Baby monitor sensitivity
You can adjust the sensitivity of the baby
monitor. Increase or decrease the sensitivity to
adjust the sound level needed to trigger the
baby monitor feature.
Helpline Tel. No.: U.K. 0844 844 3899 Ireland 01289 8333
TGH22xE(en)_XA_0926_ver202.pdf
R This feature cannot be set during a
monitoring call.
1
2
3
Answering the baby monitor
n When monitoring with a handset:
Press M
If you want to respond from the monitoring
handset, press MMUTEN.
R The monitoring handset will answer calls
N
Note:
R If you receive an outside call when
n When monitoring from an outside line:
To answer a call, follow the operation for
your phone.
If you want to respond from the monitoring
handset, press #1 using tone dialling.
You can turn off the baby monitor feature
by pressing #0.
Note:
R 2 minutes after the monitored handset
Other programming
Changing the handset name
N
The default handset name is "Handset 1" to
"Handset 6". You can customise the name
of each handset ("Bob", "Kitchen", etc.). This is
useful when you make intercom calls between
handsets. To display the handset name in
standby mode, turn on the handset name
display feature (page 34).
33
Programming
Press MMENUN on the handset being
monitored.
MbN: "Sensitivity Level" a MOKN
MbN: Select the desired setting. a MOKN
a M
N
N to answer calls.
automatically when the auto intercom
feature is set to "On" (page 19).
communicating with the monitored
handset, you hear 2 tones. To answer
the call, press M
N, then press M
starts a call, communication between the
monitored handset and monitoring
phone line is turned off automatically.
2014/09/26
10:04:45
N.
33
Advertisement
Table of Contents
