Unpacking - Ice-O-Matic CD40030 Service & Installation Manual

Unpacking

After removing the carton, check for the loose-shipped parts packed in the storage bin. The
parts will include a carton with four legs. Remove the leg carton and any other loose-shipped
items.
To remove the skid, place part of the carton behind the unit and tip the unit on its back.
Remove the bolts holding the skid to the base of the CD dispenser and separate the skid
from the unit.
Install the legs into the base of the unit, using the holes where the skid bolts were. Turn the
leg leveler part of the legs in all the way, adjust them later after the unit is in its final installed
position.
Move the dispenser to an upright position and set it in the location where it will be installed.
Note where the drain lines and electrical connections will be made.
Front Panel Removal
The front panel rests on the base and is located with pins that stick up from the base. It is
retained to the side panels by strikes and latches. The top panel keeps the front panel from
moving forward.
To remove:
1. Disconnect electrical power.
2. Remove the two screws holding the
top panel to the dispenser. Lift the top
panel up and off the dispenser.
3. Pull the top edge of the front panel
forward until the two snaps disengage.
•If the unit is a coin op model, reach
behind the front panel and
disconnect the coin mechanism
harness from the front panel.
•If the unit is a water dispenser
model, reach behind the front panel
and shut off the water supply valve
to the water faucet. Then disconnect
the water line from the shut off valve.
4. Lift the front panel up and off the
base.
Page 7
CD40030/CD40022