Baumatic BWC150SS User Manual page 25

15 cm 7 bottle built-in wine cabinet
Table of Contents

Advertisement

IMPORTANT: Check that the door opens and shuts correctly,
without fouling, after you have completed the door reversal
process.
After the door has been reversed, you should check
the door seal of the wine cabinet. The seal should
not be creased or crushed; otherwise there will be a
gap between it and the inside of the door.
o The seal must adhere properly all the way around the door.
o If the seal is not adhering to the cabinet properly, then you
should either:-
a) Use a warm damp cloth and manipulate the seal until it does
adhere to the cabinet properly, all the way around the door.
or
b) Use a hair dryer on its lowest heat setting and lightly heat the
areas of the door seal that are not adhering correctly. The heat
will make the seal more pliable and this will allow you to
manipulate the seal into the correct position.
IMPORTANT: DO NOT HEAT THE DOOR SEAL ON ANYTHING BUT
THE LOWEST HEAT SETTING, OR HEAT THE SEAL FOR A LONG
PERIOD OF TIME. OTHERWISE DAMAGE MAY BE CAUSED TO
THE DOOR SEAL, WHICH WOULD NOT BE RECTIFIED UNDER
THE GUARANTEE FREE OF CHARGE.
IMPORTANT: WHEN YOU HAVE REVERSED THE DOOR OF THE
APPLAINCE, IF YOU HAVE PLACED THE APPLIANCE ON ITS
o Take the left top hinge and left
lower hinge from the plastic
bag
that
contained
manual then install them in
the designated positions on
the left side of the cabinet.
o Turn the glass door around
180° and reinstall it.
this
25

Advertisement

Table of Contents
loading

Table of Contents