Functional Description - Makita XTS01 Instruction Manual

FUNCTIONAL DESCRIPTION

CAUTION:
Always be sure that the tool is switched off and the
•
battery cartridge is removed before adjusting or
checking function on the tool.
Installing or removing battery cartridge
1
2
014790
Always switch off the tool before insertion or
•
removal of the battery cartridge.
To remove the battery cartridge, withdraw it from
•
the tool while sliding the button on the front of the
cartridge.
To insert the battery cartridge, align the tongue on
•
the battery cartridge with the groove in the housing
and slip it into place. Always insert it all the way
until it locks in place with a little click. If you can
see the red part on the upper side of the button, it
is not locked completely. Insert it fully until the red
part cannot be seen. If not, it may accidentally fall
out of the tool, causing injury to you or someone
around you.
Do not use force when inserting the battery
•
cartridge. If the cartridge does not slide in easily, it
is not being inserted correctly.
Safety system
1
014791
Make sure all safety systems are in working order
before operation. The tool must not operate if only the
switch trigger is pulled or if only the safety lever is
pressed against the wood. It must work only when both
actions are performed. Test for possible faulty operation
with a tool unloaded and pointed well away from
yourself or any bystanders.
1. Red part
2. Button
3. Battery cartridge
3
1. Trigger
2. Safety lever
2
NOTE:
There is a possibility that the tool may operate for
•
an instant when only the trigger is pulled. This
does not indicate a problem. If this occurs, point
the tool well away from yourself or any bystanders.
Release and pull the trigger again to make sure
the safety systems are in working order.
ASSEMBLY
CAUTION:
Always make sure that your fingers are not placed
•
on the trigger and the battery cartridge is removed
before carrying out any work on the stapler.
Staples
Handle the staples and their box carefully. If the
•
staples have been handled roughly, they may be
bent out of shape, causing poor staple feed or
jamming.
Avoid storing the staples in a very humid or hot
•
place or place exposed to direct sunlight.
CAUTION:
Do not use staples other than designated in this
•
manual or staples that appear to be damaged,
bent, rusty or corroded.
Do not insert staples of which size is different each
•
other at the same time inside the magazine ,
causing poor staple feed or jamming.
Loading staples
Remove the battery cartridge.
Press the locking lever on the rear of the sub magazine
and slide the sub magazine backward.
014792
Load staples into the main magazine with their feet
facing up. Slide the sub-magazine forward.
5
1. Sub magazine
1
2. Locking lever
2