Siemens SIMATIC IFP2200 INOX MT ETH Compact Operating Instructions page 35

ATEX/IECEx approval
Notes on use in hazardous areas
Observe the following FAQ regarding the use of an HMI device in hazardous areas: ATEX-FAQ
(https://support.industry.siemens.com/cs/ww/en/view/291285)
When using the device in hazardous areas, ensure that all plugs connected to the device are
secured in a captive manner, see section "Securing cables for use in hazardous areas
(Page 26)".
You can find more information about explosion protection, EC/EU declarations of conformity
and other certificates on the Internet at the following address:
Certificates for Flat Panels (https://support.industry.siemens.com/cs/ww/en/ps/24423/cert)
ATEX approval
For an HMI device with "Ex" marking, the following approvals apply according to the
following standards.
• Standards:
– EN IEC 60079-0:2018
– EN IEC 60079-7:2015 +A1:2018
– EN 60079-31:2014
• Approvals:
IECEx approval
For an HMI device with "IECEx" marking, the following approvals apply according to the
following standards.
• Standards:
– IEC 60079-0:2017
– IEC 60079-7:2017
– IEC 60079-31:2013
• Approvals:
RCM Declaration of Conformity for Australia/New Zealand
This product meets the requirements of the standards:
• AS/NZS 61000.6.4
• IEC 61000-6-4
IFP2200 INOX MT ETH
Compact Operating Instructions, 07/2021, A5E42185570-AD
II 3 G Ex ec IIC T4 Gc
II 3 D Ex tc IIIC Dc
Ex ec IIC T4 Gc
Ex tc IIIC Dc
Technical specifications
5.2 Certificates and approvals
35