Notes On Installation; Checking Clearances - Siemens SIMATIC IFP2200 INOX MT ETH Compact Operating Instructions

3.1.4

Notes on installation

Mounting cutout
The HMI device can be installed in control cabinets (see table for material thickness). No
special tools are required for mounting. The HMI device can be operated both in landscape
and portrait format with a vertical inclination of up to +/-35°. Due to the surrounding beveling
of the stainless steel front of 45°, liquids are able to drain off even in an inclined installation
position of +/-35°.
The following conditions apply to the mounting cutout:
The front material has to consist of sheet steel or material of a strength that corresponds to at
least the stability of sheet steel.
Mounting cutout
Material thickness
Permitted deviation from plane
This condition must be fulfilled for the mounted HMI device.
Permitted surface roughness in the area of the mounting seal
3.1.5

Checking clearances

The following clearances are required around the device to ensure adequate self-ventilation:
• At least 15 mm to the right and left of the mounting cutout (in x direction) to allow for
insertion of the mounting clips during installation
• At least 50 mm above and below the mounting cutout (in y direction) for ventilation
• At least 10 mm behind the rear panel of the device (in z direction)
The figure below shows the clearances required with horizontal and vertical installation of
the device:
①
②
x
y
z
IFP2200 INOX MT ETH
Compact Operating Instructions, 07/2021, A5E42185570-AD
Clearance for horizontal installation (all devices)
Clearance for vertical installation (monitor and touch versions only)
At least 15 mm distance
At least 50 mm distance
At least 10 mm distance
Installing and connecting the device
3.1 Preparing for installation
Dimensions
1.5 to 6 mm
≤ 0.5 mm
≤ 120 µm (R 120)
z
19