Siemens SIMATIC IFP2200 INOX MT ETH Compact Operating Instructions page 23

Similar to figure
1. Working from the front, insert the device with inserted mounting seal into the mounting
cut-out.
2. Place the clamping frame from the rear on the stainless steel front of the device.
3. Insert one of the provided mounting clips into the guide slot at the upper right-hand corner
and tighten the setscrew only until its point comes to rest in the center hole on the clamping
frame as shown in the picture detail.
– It must still be possible to move the mounting clip without the setscrew getting loose.
– Insert two mounting clips in the same way into the opposite (diagonal) corners.
– Order of action: ③-④-⑤-⑥
4. Insert the remaining mounting clips one after the other.
5. Check the correct fit of the mounting seal.
– The edge of the mounting seal must be flush on all sides with the stainless steel front.
– The edge may protrude by about 0.1 to 0.5 mm.
IFP2200 INOX MT ETH
Compact Operating Instructions, 07/2021, A5E42185570-AD
If necessary, loosen the setscrew or tighten it a little.
Installing and connecting the device
3.3 Mounting the device
23