Registering A Unit - Panasonic KX-TGK222E Operating Instructions Manual

area codes here prevents the restricted
handsets from dialling any phone number in
that area code.
1
MMENUN#256
2
Enter the base unit PIN (default: "0000").
R If you forget your PIN, see page 43.
3
MbN: Select the handsets to be restricted.
a MSELECTN
R " " is displayed next to the selected
handset numbers.
R To cancel the selected handsets:
MbN: Select the handset. a Press
MSELECTN again. " " disappears.
4
MOKN
5
MbN: Select a memory location. a MOKN
6
Enter the phone number or area code to
be restricted (8 digits max.). a MOKN a
M N
Enhancing security for phone
calls
You can increase the security of phone
conversations by setting this feature to
"Enhanced". When "Enhanced" is selected,
is displayed. The default setting is
"Normal".
1
MMENUN#729
2
MbN: Selected the desired setting. a MOKN
3
M N
Note:
R If you set repeater mode to "On"
(page 32):
– Security is set to "Normal" and
displayed.
– "Security" is not displayed in the
display menu (page 26).
R When enhanced security is enabled, sound
may cut in and out during conversations.
Changing the base unit PIN
Important:
R If you change the PIN (Personal
Identification Number), please make note of
Helpline Tel. No.: U.K. 0344 844 3899 Ireland 01289 8333
your new PIN. The unit will not reveal the
PIN to you. If you forget your PIN, see
page 43.
1
MMENUN#132
2
Enter the current 4-digit base unit PIN
(default: "0000").
3
Enter the new 4-digit base unit PIN. a
MOKN
4
MbN: "Yes" a MOKN a M

Registering a unit

Operating additional units
Additional handsets
Up to 6 handsets can be registered to the
base unit.
Important:
R The additional handset model
recommended for use with this unit is noted
on page 4. If another handset model is
used, certain operations may not be
available.
Additional base units
Handsets can be registered to up to 4 base
units, allowing you to add additional base units
and extend the area in which your handset(s)
can be used. If a handset moves out of range
of its base unit when "Auto" is selected on
base unit (page 32), it looks for another
base unit to make or receive calls. A base unit
and the handsets it communicates with is
is
called a "radio cell".
Note:
R Calls are disconnected when the handset
moves from one radio cell to another.
Registering a handset to a base
unit
The supplied handset and base unit are
pre-registered. If for some reason the handset
is not registered to the base unit (for example,
Programming
N
31