Panasonic KX-TGK222E Operating Instructions Manual page 32

Programming
is displayed even when the handset is
near the base unit), re-register the handset.
1
Handset:
MMENUN#130
2
MbN: Select a base unit number. a MOKN
R This number is used by the handset as
a reference only.
3
Base unit:
Press and hold M
R If all registered handsets start ringing,
press M N again to stop, then repeat
this step.
4
Handset:
MOKN a Wait until "Base PIN" is
displayed. a Enter the base unit PIN
(default: "0000"). a MOKN
R If you forget your PIN, see page 43.
Selecting a base unit
When "Auto" is selected, the handset
automatically uses any available base unit it is
registered to. When a specific base unit is
selected, the handset makes and receives
calls using that base unit only. If the handset is
out of range of that base unit, no calls can be
made.
1
MMENUN#137
2
MbN: Select the desired base unit number,
or "Auto". a MOKN
Important:
R When viewing the phonebook, caller list,
etc., only the entries that are stored in the
base unit that the handset is currently
connected to are displayed.
Deregistering a handset
A handset can cancel its own registration to
the base unit, or other handsets registered to
the same base unit. This allows the handset to
end its wireless connection with the system.
1
MMENUN#131
R All handsets registered to the base unit
are displayed.
2
MbN: Select the handset you want to
cancel. a MOKN
3
MbN: "Yes" a MOKN a M
32
N for about 5 seconds.
N
Helpline Tel. No.: U.K. 0344 844 3899 Ireland 01289 8333
Cancelling a base unit
A handset can cancel a base unit that it is
registered to. This allows the base unit to end
its wireless connection with the system.
1
MMENUN#139
2
MbN: Select the base unit you want to
cancel. a MOKN
3
MbN: "Yes" a MOKN a M
Increasing the range of the base
unit
You can increase the signal range of the base
unit by using a DECT repeater. Please use
only the Panasonic DECT repeater noted on
page 4. Contact your Panasonic dealer for
details.
Important:
R Before registering the repeater to this base
unit, you must turn the repeater mode on.
R Do not use more than one repeater at a
time.
Setting the repeater mode
1
MMENUN#138
2
MbN: Select the desired setting. a MOKN
a M N
Registering the DECT repeater
(KX-A405/KX-A406) to the base unit
Note:
R Please use a repeater that has not yet been
registered to another unit. If the repeater is
registered to another unit, deregister it first,
referring to the Installation Guide for the
DECT repeater.
1
Base unit:
Press and hold M
2
DECT repeater:
Connect the AC adaptor, then wait until
the indicator and
green.
3
Base unit:
To exit the registration mode, press M
N
N for about 5 seconds.
indicator light
N.