Removing Collected Water - Gree GPC10AL-K6NNA1A Service Manual

8. Install
8.1 Install Wire Hook
● Assemble the wire hook at the back of the unit with screws.(As show in Fig.1)
direction of wire hook is upward
wire hook
screw
Fig.1
● Wind the power cord around the wire hook.(As show in Fig.2)

8.2 Removing Collected Water

There are 2 ways to remove collected water:
1. Use the continuous drainage option from the lower hole.
NOTICE:When using the continuous drainage option from the bottom hole, install drainage pipe as follow before using, otherwise poor
drainage will affect normal operation of the unit.
● Instructions for drainage pipe installation.
(1) Fix the drainage pipe clip on the right of rear side plate near
drainage port with a screw.(As show in Fig.3)
(2) Remove the rubber plug at drainage port.(As show in Fig.4)
(3) Put the drainage pipe into drainage port and screw it up, and
then bind it with pipe hoop.
(4) Put the rubber plug into the other side of drainage pipe, fix it
with pipe hoop and then fix it in the drainage pipe clip.(As show in
Fig.5)
drainage pipe
drainage port
Fig.5
26
direction of wire hook is downward
pipe hoop
rubber plug
drainage pipe clip
pipe hoop
Fig.2
drainage port
Fig.3
drainage port
Fig.4
Service Manual
drainage pipe clip
screw
Maintenance