Advertisement
This Remote Start System is designed to be used with
Automatic Transmission- Fuel Injection Vehicles Only!
INSTALLATION OF THE MAJOR COMPONENTS:
CONTROL MODULE: (P/N 1365607)
Select a mounting location inside the passenger compartment (up behind the dashboard).
The mounting location selected must be within 24" of the ignition switch wiring harness
to allow connection of the 6 pin main wiring harness.
Be certain that the chosen location will not interfere with proper operation of the vehicle.
Avoid mounting the module to or routing the wiring around the steering shaft/column,
as the module or wiring may wrap around or block the steering wheel preventing proper
control of the vehicle. Secure the module in the chosen location using cable ties or
screws as necessary.
Do Not Mount The Module In The Engine Compartment, as it is not waterproof.
THE RECEIVER/ANTENNA VALET SWITCH LED ASSEMBLY: (P/N 1181256)
The Superheterodyne Receiver Antenna Assembly which includes the LED and Valet/
Programming switch provided with this unit allows routing from below the dash board
for maximum operating range. Choose a location above the belt line (dashboard) of
the vehicle for best reception. Special considerations must be made for windshield
glass as some newer vehicles utilize a metallic shielded window glass that will inhibit
or restrict RF reception. In these vehicles, route the antenna toward a rear window
location for best reception. Secure the antenna with double stick tape provided. After
securing the antenna with tape, we advise also securing a section of the antenna cable
to a fixed support. This will prevent the antenna from dropping down in case the double
stick tape is exposed to extreme heat which may loosen it's gummed surface. Route
the connector toward the control module using caution not to pinch the cable as this
will cause poor or no RF reception to the control module. Connect the 5 pin cable to the
mating connector of control module.
HOOD PIN SWITCH: (P/N 1363699)
The pin switch included in this package are intended for protecting the hood area of
the vehicle. In all cases, the switch must be mounted to a grounded metal surface.
When the pin switch is activated, (hood/trunk open), it will supply a ground to the input
wire to inhibit the remote start function. In addition, the hood switch is required for the
safety shut down of the remote start unit. If the vehicle is being worked on, this hood
switch prevents the remote start activation even if the RF command to start is issued.
WARNING!: This switch must be installed in all applications. Failure to do so may
result in personal injury or property damage.
Mount the switch in the hood locations away from water drain paths. If necessary, a
bracket may be used to move the switch away from rain gutters or allow mounting to
the firewall behind the hood seal. In both cases the switch must be set up to allow the
hood to depress the switch at least 1/4 inch when the hood is closed and fully extended
when the hood is opened. For direct mounting, a 1/4 inch hole must be drilled. Care-
fully check behind the chosen location to insure the drill will not penetrate any existing
factory wiring or fluid lines.
Drill a 1/4" hole in the desired location and thread the pin switch into it using a 7/16" nut
driver or deep well socket. If using the mounting bracket, first secure the bracket to the
desired location and secure the pin switch in the pre-threaded mounting bracket hole.
DO NOT PLUG THE SIX PIN MAIN POWER HARNESS OR THE MULTI PIN INPUT
/ OUTPUT HARNESS INTO THE CONTROL MODULE UNTIL ALL CONNECTIONS
TO THE VEHICLE HAVE BEEN MADE. AFTER SELECTING YOUR TARGET WIRES
AS DEFINED BELOW, DISCONNECT THE NEGATIVE BATTERY CABLE FROM THE
VEHICLE BATTERY PRIOR TO MAKING ANY CONNECTIONS.
CAUTION: Do not remove the fuse holders from this wire harness. Fuses must
be used and located as close as possible to the power source for adequate pro-
tection of the vehicle.
Page 4
128-9482
4 of 16
Advertisement
