matson MA40DCS Manual

matson MA40DCS Manual

Dc-dc charger with solar input

Advertisement

DC-DC CHARGER
WITH SOLAR INPUT
The MA21DCS and MA40DCS are sophisticated multi-stage chargers, utilising
microprocessor control and solid state technology to charge most 12V AGM/Lead Acid,
Gel, Calcium and LiFePO batteries.
Heavy duty aluminium case and mounting brackets
Encapsulated and sealed to IP65 for under
bonnet applications
Microchip monitoring and control
Fully automatic high frequency multi
stage charging
Pulse mode technology that reduces oxidation,
evens electrolyte consistency and minimises
temperature equating to longer battery life
Easy push button chemistry selection: Lead Acid/
AGM (including VRLA and conventional flooded
batteries), Gel, Calcium and LiON (LiFePO4)
LED indicators showing stage of charge
MANUAL
Internal charger temperature monitoring
and power output control
Over charging, short circuit and over temperature
protection
Reverse polarity protection:
1. Input reverse polarity protection
2. Output reverse polarity protection
Thermal overload protection
Solar input overload protection
Power cut memory function: once selected, the charger
will remain on this battery type until it is changed
MPPT solar charge control
MA21DCS . MA40DCS

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the MA40DCS and is the answer not in the manual?

Questions and answers

Summary of Contents for matson MA40DCS

  • Page 1 DC-DC CHARGER WITH SOLAR INPUT The MA21DCS and MA40DCS are sophisticated multi-stage chargers, utilising microprocessor control and solid state technology to charge most 12V AGM/Lead Acid, Gel, Calcium and LiFePO batteries. Heavy duty aluminium case and mounting brackets Internal charger temperature monitoring ●...
  • Page 2 The warnings, cautions and instructions detailed in this instruction manual cannot cover all possible conditions and situations that may occur. Common sense and caution are factors which cannot be built into this product and must be supplied by the operator. MA21DCS . MA40DCS . MANUAL...
  • Page 3 Any existing or additional cables used in the installation of this product needs to be suitable for the current and distance required. Matson recommends the use of 10mm2 cable for this purpose as a minimum. Solar Panels...
  • Page 4 Connect the main battery to the charger - make sure polarity (+ & -) are correct ● It is recommended that a 25 Amp (MA21DCS) / 40 Amp (MA40DCS) circuit breaker or fuse be installed ● between the main battery and the charger, but is not essential Make sure all connections are tight ●...
  • Page 5 12.4V. Minimum solar input voltage is 13.5V, maximum is 25V. No regulator is required between the charger and the panels if the panel output voltage is within those parameters. MA21DCS . MA40DCS . MANUAL...
  • Page 6 4 AWG or 25mm WARNING: Failure to use recommended wiring will severely impact on performance of DC to DC charger. Charging algorithm will change according to battery type. 13.0 25.0 15.4 13.0 15.4 14.4 (LiON) MA21DCS . MA40DCS . MANUAL 13.5 13.5 13.5...
  • Page 7 100% 1.265 12.65 Voltage reading and specific gravity of electrolyte 1.225 12.45 (lead acid batteries) can give an indication of your 1.190 12.24 battery’s state of charge. 1.155 12.06 1.120 11.89 MA21DCS . MA40DCS . MANUAL...
  • Page 8 Tridon Australia will bear costs associated with claiming legitimate warranties. Proof of expenses incurred must be submitted to Tridon Australia Pty Ltd. MA21DCS . MA40DCS . MANUAL...

This manual is also suitable for:

Ma21dcs

Table of Contents