CAUTION:
!
Microphone set cable is attached to mainboard. Use caution when removing
upper cover.
7. Lift upper cover in an angle to expose microphone set cable (Figure 3-22).
8. Disconnect microphone set cable (N) from mainboard connector (P) (Figure 3-22).
Figure 3-22. Microphone Set Cable
9. Remove upper cover.
Upper Cover Installation
1. Align upper and lower cover.
2. Connect microphone set cable (N) to mainboard connector (P) (Figure 3-22).
3. Install upper cover on lower cover.
4. Press along edges to secure all latches.
5. Install and secure five (5) screws (A) to upper cover
6. Connect the following cables
Fingerprint board FFC cable (E) to mainboard connector (F)
Touchpad button assembly FFC cable (G) to mainboard connector (H)
Function board cable (J) to mainboard connector (K).
7. Place computer face down.
8. Install and secure the following screws
Thirteen (13) screws (B) to lower cover
Two (2) screws (C) to lower cover
Three (3) screws (D) to battery bay.
9. Install keyboard.
Machine Maintenance Procedures
N
P
(Figure
3-20):
(Figure
(Figure
3-20).
3-19):
0
3-19