Start-Up; Multi-Stage Centrifugal Blower Operation And Use - Unimac PPTSPYUMCAH02 User Manual

Electric HVLP Paint Sprayer
•
To select the type of spray required (Fig. 6), loosen the adjustment ring (#84), adjust the position, orienting
the nozzle (#83) to obtain: HH = horizontal spray, VV = vertical spray, CC = round spray (Fig. 6).
The gasket includes four orientation notches that help position the butterfly nozzle (#83). The position is
fixed by a tab that protrudes from the bottom.
•
After selecting the type of spray, tighten the adjustment ring (#84).
•
The horizontal or vertical sprays (HH – VV) are recommended for large surfaces. The round spray (CC) is
used instead for small objects or for areas that are difficult to reach (corners, angles, etc.).

Start-Up

Turn the switch (#4) to start the atomiser (or the multi-stage centrifugal blower).
Multi-Stage Centrifugal Blower Operation and
Use
•
The atomiser supplies the compressed air needed to operate the machine.
•
Air flows from the butterfly nozzle (#83) and paint is sprayed only when the trigger is pulled (#77).
5