Specifications - Unimac PPTSPYUMCAH02 User Manual

Electric HVLP Paint Sprayer
For safety reasons and to ensure correct operation, the reservoir is not hermetically sealed. Even after it is
completely closed, a small flow of air may still be present.

Specifications

Fluid Nozzle
Spray Gun Tank Capacity
Air Hose Length
Power Supply
Rated Power
￠1.8mm (1.0-1.8mm)
1 Litre
1.5 Meters
230/50Hz
450W
If the spray is still not fine enough

or the flow is inadequate, try
thinning the paint a little more.
Do not thin bulk amounts of paint

until you have determined the
ideal amount and tested it through
the sprayer.
Blockage:
As outlined in the product manual

it is extremely important to
thoroughly flush the sprayer
immediately after use.
Use water to flush out water-

based paint.
Use turps to flush out oil based

paint.
Spray oil/turps through the

sprayer in exactly the same way
you use paint.
You must run enough water/turps

through the sprayer to ensure
absolutely all paint has been
removed from the system. Keep
spraying until there's absolutely no
paint coming out - the oil/turps
should be completely clear.
Then complete clean-up by

thoroughly removing all paint
residue from the spray nozzle, the
paint inlet and the rest of the
machine.
Any trace of paint left in the unit or

around the inlet or nozzle will
prevent the sprayer from working
properly.
Simply let our team know the unit

is blocked and they will advise the
easiest solution for un-blocking.
12