Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for John Lewis JLCHT8501
Summary of Contents for John Lewis JLCHT8501
- Page 1 Instruction Manual JLCHT5201/JLCHT8501 52cm/85cm Cooker hood...
-
Page 2: Table Of Contents
Contents Instruction Manual JLCHT5201/JLCHT8501 52cm/85cm Cooker hood Introduction Safety is important In the box Safety information Important safety information Warnings Cautions Electrical information Operation Care and cleaning Cleaning and replacing aluminium filters Cleaning and replacing charcoal filters Installation Installing the cooker hood... -
Page 3: Introduction
These warnings have been provided in the interest of safety. You MUST read them carefully before using the appliance. If you are unsure of the meanings of these warnings contact the John Lewis branch from which you purchased the appliance or our Technical Support centre on 0330 123 0106. -
Page 4: Safety Information
To avoid accidents to property or people it is important to follow the instructions given. Failure to do so removes any liability from John Lewis. Warnings – Any installation work must be undertaken by a qualified electrician or competent person. -
Page 5: Cautions
Should the power supply cable need to be replaced, this must be carried out by an approved service engineer. John Lewis declines any liability should this safety measure not be observed. Before switching on, make sure the electricity supply voltage is the same as that indicated on the cooker hood’s rating plate. -
Page 6: Operation
Operation Instruction Manual JLCHT5201/JLCHT8501 The controls are (left to right): 52cm/85cm Cooker hood Light. Press this button to switch the lights in the cooker hood on or off. Off/Reduce Fan Speed. If the cooker hood is: – On at fan speed 1, press this button to switch the cooker hood off. -
Page 7: Care And Cleaning
The model numbers are: – for JLCHT5201, model number JLCHF07 – for JLCHT8501, model number JLCHF02 Charcoal filters are designed to absorb grease, dust and unwanted odours during cooking. They are only required when the cooker hood is used for recirculating (i.e. - Page 8 To replace the charcoal filters: Instruction Manual JLCHT5201/JLCHT8501 1. Open the glass (A). 52cm/85cm Cooker hood 2. Remove the aluminium filter (B) by turning the handle towards the rear of the cooker hood and pulling the filter downwards. 3. Pull the tab to release the charcoal filter (C) and remove it.
-
Page 9: Installation
1. Cut a hole in the bottom of the cabinet to hold the cooker hood. The dimensions of the hole are: – 265mm x 498mm (JLCHT5201) – 265mm x 835mm (JLCHT8501) 2. Prepare the power supply (see page 5). 3. Prepare the hole for the exhaust (see above) in the top of the cabinet or the wall or ceiling of the room. -
Page 10: Blocking The Stop Valve
8. Insert the cooker hood in the cabinet. Instruction Manual JLCHT5201/JLCHT8501 9. Insert the screws (F) in the front and rear of the cooker hood to hold it 52cm/85cm Cooker hood in position. 10. Insert the steel bar and LED bar. -
Page 11: Guarantee
Disposal This symbol indicates that this product should not be treated as normal household waste and it should be recycled. John Lewis do not operate instore take back, but as members of the Distributor Take Back scheme have funded the development and upgrade of recycling facilities across the UK. -
Page 12: Troubleshooting
If none of the above suggestions resolve the problem please contact your local John Lewis branch. Never attempt to repair the cooker hood yourself. Replacing LED lights Your cooker hood is fitted with LED light strips. They should only be... -
Page 13: Specifications
Specifications Instruction Manual JLCHT5201/JLCHT8501 Specifications of the cooker hood that you have just purchased may vary 52cm/85cm Cooker hood from the information in this table due to technical innovations. Model Number JLCHT5201 JLCHT8501 Type Cooker Hood Cooker Hood Dimensions 520mm wide x 290mm deep... - Page 14 John Lewis Partnership 171 Victoria Street London SW1E 5NN johnlewis.com Please retain these instructions for future reference...