Removing The Keyboard/ Lcd Module And Vga Board; Removing The Keyboard; Removing The Lcd Module And Vga Board - Acer TravelMate 430 Service Manual
Hide thumbs
Also See for TravelMate 430:
- Manuel d'utilisation (82 pages) ,
- Guía del usuario (82 pages) ,
- Guia do usuário (82 pages)
Table of Contents
Advertisement
Removing the Keyboard/ LCD Module and VGA Board
Removing the Keyboard
1.
Remove the two screws holding the hinge caps then remove the hinge caps.
2.
Unscrew the four screws holding the keyboard.
3.
Use a tool to press the keyboard lock latch on the right and the left side.
4.
Turn over the keyboard as the picture shows.
5.
Disconnect keyboard FFC then remove the keyboard.
6.
Then detach the middle cover carefully.
Removing the LCD module and VGA Board
1.
See "Removing the Keyboard" on page 65.
2.
Remove one screw as the picture shows.
3.
Remove the six screws on the rear panel and buttom panel. Three on each side.
4.
Unscrew the four screws holding the VGA board assembly to the main board.
NOTE: Please make sure you have remove the screw that is near the ventilation hole as step 2 shows.
Otherwise, you may damage the VGA board while you need to remove it. That screw secures the VGA
board as well.
5.
Disconnect the LCD inverter connector.
Chapter 3
65
Advertisement
Table of Contents
