Stalling On A Hill; Tires; Slippery Terrain; Battery Charging - Cushman HAULER PRO 2022 Owner's Manual

Table of Contents

Advertisement

S
AFETY

Stalling on a Hill

A rollover can result from stalling or rolling backward while climbing a hill. Drive uphill at a constant speed. See proce-
dure on page 31 for maintaining control of your vehicle if it stalls on a hill.

Tires

Operating the vehicle with incorrect tires or with incorrect or uneven tire pressure can cause loss of control or an acci-
dent. Always use the size and type tires specified for the vehicle. See VEHICLE SPECIFICATIONS on page 53.
Always maintain correct tire pressures as specified in Tire Pressure on page 15.

Slippery Terrain

Driving on rough, wet or loose terrain increases the risk of loss of traction or control, accident or rollover. Drive slowly
and use correct turning procedures when operating on slippery surfaces.
Tires that have lost traction, and then regain traction suddenly, can cause loss of vehicle control or rollover.
Refer to Slippery Surfaces on page 30 for operational information.

BATTERY CHARGING

Charging should be performed when ambient temperatures are between 40°F and 110°F (4°C and 42°C). The battery
pack may be charged or topped off after every use.
The battery management system (BMS) and charger cooperate to make sure that charging occurs at the proper rate
for the battery temperature. When the battery charger is connected to the vehicle, it will determine the charge rate
based on the battery temperature. The charger will operate at the rates shown in the table below.
Charge Rate
NO charging
Pre-charge (charge at reduced rate, 6 amps)
Full charging
The BMS will adjust the charge rate based on the temperature of the batteries.
Use only the OEM approved Lithium-Ion battery charger for your vehicle. Turn the key to the OFF position and remove
it.
• Inspect the charger cord for cracks, frayed wires or loose connections, if damaged, replace it.
• Inspect the vehicle charger receptacle and charger plug for dirt, debris or damage. Clean if necessary and replace
immediately if damage is found.
• Connect the charger to a wall receptacle. Do not use a multi-plug adapter or power strip. Do not connect anything
else to the same receptacle.
• Connect the charger to the vehicle receptacle.
• When the battery pack is finished charging, disconnect the charger cord from the vehicle. If disconnecting before
the charge cycle is complete, it is recommended that the charger be disconnected from the wall receptacle first,
then unplug the charger from the vehicle receptacle.

VEHICLE LIFTING

The vehicle must be on a firm and level surface for lifting. Remain constantly aware that the vehicle is not stable
during the lifting process. Do not get under a vehicle until you verify that it is stable on the jack stands. Never get
under a vehicle while it is on a jack only. Put wheel chocks in front and behind the wheels that are not being lifted. Do
not allow anyone to remain or get on the vehicle at any time during the lifting process.
Read and comply with all warnings and follow the lifting procedures described on page 44.

VEHICLE MODIFICATION

Do not install any accessory not approved by TSV. Do not modify the vehicle to increase speed or power. Any modifi-
cations or installation of accessories not approved by TSV can create a safety hazard and increase the risk of injury.
The warranty will be terminated if the vehicle is modified to increase vehicle speed or power.
The warranty may be terminated if original (or equivalent) replacement parts are not installed on the vehicle.
The addition of some accessories can change the handling characteristics of the vehicle. Use only TSV approved
accessories, and familiarize yourself with their function and effect on the vehicle.
18
Temperature
below 14° F (-10°C) or above 140°F (60°C)
between 14°F (-10°C) and 41°F (5°C)
between 104°F (40°C) and 140°F (60°C)
between 41°F (5°C) and 113°F (45° C)

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents