Setting An Indoor Unit Address And Installation Option - Samsung AC018MNHDCH/AA Service Manual

4-4 Setting an indoor unit address and installation option

Set the indoor unit address and installation option with remote controller option. Set the each option
separately since you cannot set the ADDRESS setting and indoor unit installation setting option at the same
time. You need to set twice when setting indoor unit address and installation option.
Setting an indoor unit address
1) Press the and
displayed.
2) Press the / button to select
3) Press the / button to select and then press
Data bit
1 2 3 4 5 6
The Main/RMC Address which is currently setting will flicker.
Data bit 1 and 2 present Indoor unit main address checking
NOTE
Data bit 3 and 4 present Indoor unit main address setting(outdoor unit reset is needed to set).
Data bit 5 and 6 present Indoor unit RMC address setting/checking.
4) Press the / button to set the Indoor unit Main/RMC Address.
5) Press the button to save and complete the option setting.
6) Press the button to exit to normal mode.
Press the
NOTE
Address will not be applied if you don't press
Setting Main/RMC Address of an Indoor unit is available only with a master wired remote controller.
4-14
buttons at the same time for more than 3 seconds and then a Main menu will be
and then press
button anytime during setup to exit without setting.
button to enter a Sub-menu setting screen.
button to enter a Indoor Address setting screen.
button.
Samsung Electronics