Mounting The Gps Antenna Inside The Vehicle; Mounting The Microphone; Installation Example Using The Original Mounting Bracket; Note On Using Hdmi Connection Cables - Alpine INE-W987A Owner's Manual

Mounting the GPS Antenna inside the vehicle

1
Clean the mounting location.
2
Put on the GPS Antenna mounting plate.
3
Mount the GPS Antenna.
This unit
• Do not mount the GPS Antenna inside the centre console.
- Mount the GPS Antenna on a flat plane of the dash board or rear
tray.
- Make sure the GPS Antenna is not covered (obstructed) by any
metallic surface or object.
• If the GPS Antenna is mounted near the unit, the reception becomes
poor, and the location of your vehicle may not be displayed correctly.
- Mount the GPS Antenna far away enough from the unit.
- Bundle the GPS Antenna cable away from the rear of the unit.
• Some thermal reflection type or thermal absorption type glass may
interrupt high frequency waves. If reception is poor with the antenna
installed inside the car, try to mount the antenna outside the car.

Mounting the Microphone.

For safe use, make sure of the following:
• Location is stable and firm.
• Driver's view and operations are not obstructed.
• Microphone is located where the driver's voice can be easily
picked up (for example, on the sun visor).
When you speak into the microphone, you should not have to change
your driving posture. This may cause a distraction, taking your
attention away from safely driving your vehicle. Carefully consider
direction and distance while mounting the microphone. Confirm that
the driver's voice can be easily picked up at the selected location.
Microphone
Cable clamp
(Sold separately)
94
-EN
GPS Antenna
Antenna mounting plate
Installation example using the Original
Mounting Bracket
1
Mount the original mounting bracket to the unit using
the supplied screws.
Ground Lead*
Chassis
Original Mounting Bracket
Screws (M5 × 8) (Included)
* To securely connect the ground lead, use an already installed screw on a
metal part of the vehicle (marked (
vehicle's chassis.
2
Connect all other leads of the unit according to details
described in the "Connections" (page 95).
3
Mounting the unit in a car.
• Fix the cables carefully. Do not damage them by tucking them into
movable parts, such as a seat rail, or by locating them against sharp or
pointed edges.

Note on using HDMI Connection Cables

When using HDMI connection cables, secure the cables to the HDMI
Terminals with the supplied HDMI Fixation Bracket.
1
Slide the HDMI Fixation Bracket into the grooves (A).
2
Secure it with the screw (B).
HDMI Terminal
(A)
Face plate (Included)
)) or a clean, bare metal spot on the
(A)
HDMI Fixation Bracket
(Included)
(B)