Setting Up Snmp On Informacast; Creating The M2M Relay - CyberData 011527 Setup Manual

4.0 Setting up SNMP on InformaCast

To use the buttons with InformaCast, an SNMP trap must be set up on the server. This allows the
buttons to communicate with the server when they are pressed. This utilizes the M2M (Machine
to Machine) plugin on InformaCast.
Note: It is recommended to have already set up IP Speaker groups to receive the messages
triggered by the buttons.
Note: Since the M2M Contact Closures require the IP Address of the button to function as
expected it is recommended to set up the button with either a Static IP Address or a DHCP
Address reservation.

4.1 Creating the M2M relay

1. Navigate to the InformaCast server and log into InformaCast.
2. Go to the Event Sources in the Broadcast Triggers section.
CYBERDATA INFORMACAST ENABLED WIFI BUTTON SETUP GUIDE
Figure 4-1. InformaCast Login Page
CyberData Corporation
3 Justin Court, Monterey, CA 93940
www.cyberdata.net
P 831.373.2601 | F 831.373.4193
Doc. 931822B Page 19