Table of Contents
Advertisement
Remote Starting Your Vehicle
To activate the remote start function, press and release the
seconds. The system will sound, the parking lights will flash 1 time and the system
will check the vehicle to ensure it is safe to start. If all safety parameters are correct,
the vehicle will start. The vehicle's parking lights will turn on (or flash depending on
system settings) as a visual indication that the vehicle has started and is running.
If your vehicle stalls or does not start, the system will pause 5 seconds, then try
3 more times to start the vehicle (a total of 4 attempts). The system will pause 5
seconds between each start attempt.
Remote Start Shutdown
Press and hold the
Entering the Vehicle while it is Running via Remote Vehicle Start
1.
Unlock the vehicle's doors.
2.
Enter the vehicle. DO NOT PRESS THE BRAKE PEDAL!
3.
Insert the key into the ignition switch and turn to the ON or RUN
position.
4.
Press the brake pedal. The remote vehicle starter will disengage and
the vehicle will operate normally.
To Enter & Exit the Vehicle while (Manual Transmission) Remote Start Ready
Mode is already active without cancelling Remote Start Ready Mode.
If ready mode has already been activated and you need to enter the vehicle, possibly
to retrieve an item, and will exit the vehicle without driving it, you can keep ready
mode active by following the steps below.
1.
With Ready Mode already previously set, activate the remote start.
2.
While under control of the remote start open vehicle door to retrieve
items.
3.
Exit the vehicle and close all doors.
4.
Press the
the system will verify all doors have been closed then will emit the 2
short/1 long tone and light flash pattern indicating Manual Transmission
Ready Mode is active.
Note: If the 2 short/1 long tone is not heard then Ready Mode has not been
set.
8
button for 3 seconds to turn the vehicle off.
button, the unit waits 3 seconds and then shuts down,
button 2 times within 2
caSECRS ca4B5 4280832 Owners revB
Advertisement
Table of Contents
