How To Change The Chain And Rim - Husqvarna K970 II Chain Operator's Manual

How to change the chain and rim

CAUTION! If the chain has been used and
!
is refitted it must be fitted in the same
working direction as earlier in order to
reduce segment wear and to obtain full
cutting capacity directly.
The chain must never be fitted the wrong
way round. The raker should guide the
segment at the right height in the cut.
Turn the bar when replacing the chain for maximum bar
life.
• Pull the handle backwards.
• Press the spring down on the chain tensioner handle.
Unscrew the adjusting bar nut anti-clockwise.
• Remove the cover.
10 – English
ASSEMBLING AND ADJUSTMENTS
• Remove the bar and chain.
• Remove the spring holding the two "half-moons" using
a screwdriver.
• Remove the "halfmoons", the cup guard, o-ring and
the drive sprocket.
• Assemble the parts in the reverse order.
IMPORTANT! During all reassembling, make sure that
the outer cover fits in to the inner cover, the covers may
be damaged otherwise.
Make sure that the chain adjuster pin fits into the hole on
the bar.