Lcd Setting And Display; Fault Code Display - Kodak OGX 5.48a Installation & User Manual

7. LCD Setting and Display

Setting Program:
Program Description
AC output mode
*This setting is only
28 available when the
inverter is in standby
mode (Switch off).

Fault code display:

Fault Code
60 Power feedback protection
71 Firmware version inconsistent
72 Current sharing fault
80 CAN fault
81 Host loss
82 Synchronization loss
83 Battery voltage detected different
84 AC input voltage and frequency detected different
85 AC output current unbalance
86 AC output mode setting is different
Selectable option
Single:
When the units are used in parallel with
single phase, please select "PAL" in program
Parallel:
28.
It is required to have at least 3 inverters or
maximum 6 inverters to support
three-phase equipment. It's required to
have at least one inverter in each phase or
L1 phase:
it's up to four inverters in one phase. Please
refers to 5-2 for detailed information.
Please select "3P1" in program 28 for the
inverters connected to L1 phase, "3P2" in
program 28 for the inverters connected to
L2 phase and "3P3" in program 28 for the
L2 phase:
inverters connected to L3 phase.
Be sure to connect share current cable to
units which are on the same phase.
Do NOT connect share current cable
between units on different phases.
L3 phase:
Fault Event
53
Icon on