Lcd Setting; General Setting; Setting Programs - Kodak OGX 5.48a Installation & User Manual

LCD Setting

General Setting

After pressing and holding "
button to select setting programs. And then, press "
exit.

Setting Programs:

Program Description
00 Exit setting mode
Output source priority:
01 To configure load power
source priority
Maximum charging
current: To configure total
charging current for solar
02 and utility chargers.
(Max. charging current =
utility charging current +
solar charging current)
"
button for 3 seconds, the unit will enter setting mode. Press "
" button to confirm the selection or "
Selectable option
Escape
Utility first (Default)
Solar first
SBU priority
60A (Default)
13
" button to
Utility will provide power to the
loads as first priority.
Solar and battery energy will
provide power to the loads only
when utility power is not available.
Solar energy provides power to the
loads as first priority.
If solar energy is not sufficient to
power all connected loads, utility
power will supply power the loads
with solar at the same time.
Battery energy provides power to
the loads only when solar energy
and utility power are not available.
Solar energy provides power to the
loads as first priority.
If solar energy is not sufficient to
power all connected loads, battery
energy will supply power to the
loads at the same time.
Utility provides power to the loads
only when battery voltage drops to
either low-level warning voltage or
the setting point in program 12.
Setting range is from 10A to 100A
and increment of each click is 10A.
" or " "