Table of Contents
Advertisement
Configuration
EN
This appliance has been designed to be used as an EXTRACTOR
hood (extraction of air to the outside) or as a FILTER hood (air is
recirculated indoors).
EXTRACTION VERSION
To configure the hood as the extraction version, connect the motor
outlet using a rigid or flexible pipe having an internal diameter of
not less than 120 mm, directly to the external steam and odour
extraction system.
Note Remove any activated carbon filters.
FILTER VERSION
If it is not possible to discharge the steam and odours to the
outside, the hood can be used as a filter. In this configuration, the
air and vapours are cleaned by the odour filters and recirculated
into the room via the ventilation grids on the side of the duct cover.
Note: using the hood in the filter version may increase the
perceived noise level.
8
Advertisement
Table of Contents
