Vehicle Dynamics Control Off Switch (Except Sti) - Subaru 2011 Impreza Owner's Manual

7-36
Starting and operating
! Traction mode
This mode restricts the functions of the
Traction Control System and Vehicle
Dynamics Control system and thus delays
utilizing their functions as a reaction to
vehicle behavior in comparison with the
Vehicle Dynamics Control mode. This
mode should be used in driving situations
where the vehicle dynamic performance
will improve without decreasing engine
torque control.
When the switch is pressed briefly during
engine operation, the Traction Control
OFF indicator light " " on the combination
meter illuminates in green. When the
switch is pressed again to reactivate the
Vehicle Dynamics Control system, the
Traction Control OFF indicator light " "
turns off.
! Vehicle Dynamics Control OFF
mode
This mode allows only the ABS control.
This mode should be used in an emer-
gency situation such as getting out of
snow or mud.
When the switch is pressed for more than
approximately 3 seconds during engine
operation, the Vehicle Dynamics Control
OFF indicator light " " on the combination
meter illuminates in yellow. When the
switch is pressed again to reactivate the
Vehicle Dynamics Control system, the
Vehicle Dynamics Control OFF indicator
light " " turns off.
NOTE
. When a mode other than the Vehicle
Dynamics Control mode is selected,
the Vehicle Dynamics Control system
automatically reactivates itself the next
time the ignition switch is turned to the
"LOCK" position and the engine is
restarted.
. If the switch is held down for 10
seconds or longer, the indicator light
turns off, the Vehicle Dynamics Control
system is activated, and the system
ignores any further pressing of the
switch. To make the switch usable
again, turn the ignition switch to the
"LOCK" position and restart the en-
gine.
. When the Vehicle Dynamics Control
OFF mode is selected, the vehicle's
running performance is comparable
with that of a vehicle that does not
have a Vehicle Dynamics Control sys-
tem. Do not deactivate the Vehicle
Dynamics Control system except when
absolutely necessary.
. Even when the Vehicle Dynamics
Control OFF mode is selected, compo-
nents of the brake control system may
still activate. When the brake control
system is activated, the Vehicle Dy-
namics Control operation indicator
light illuminates.
& Vehicle Dynamics Control
OFF switch (except STI)
Pressing the switch to deactivate the
Vehicle Dynamics Control system can
facilitate the following operations:
. a standing start on a steeply sloping
road with a snowy, gravel-covered, or
otherwise slippery surface
. extrication of the vehicle when its
wheels are stuck in mud or deep snow
When the switch is pressed during engine
operation, the Vehicle Dynamics Control
OFF indicator light " " on the combination