Subaru 2011 Impreza Owner's Manual page 165

3-44
Instruments and controls
! Compass calibration
1. If a "C" is displayed in the compass
window, the compass needs to be cali-
brated.
2. Drive the vehicle in a circle at 5 mph (8
km/h) or less until the display reads a
direction.
3. You can also calibrate the compass by
driving your vehicle on your everyday
routine. The compass will be calibrated
once it has tracked a complete circle.
4. To recalibrate your compass, push and
hold the compass display button for 9
seconds until a "C" appears in the
compass window.
5. Calibrate the compass according to
step 2 or step 3.
! HomeLink
Wireless Control Sys-
®
tem
The HomeLink Wireless Control System
®
can be used to activate remote control
devices such as gate operators, garage
door openers, door locks, home lighting
and security systems.
There are three HomeLink
®
mirror, each of which can be programmed
for operation of one desired device. For
details on the device types which can be
operated by this system, consult the
HomeLink website at:
®
www.homelink.com or call 1-800-355-
3515.
Note the following information about this
system.
If your vehicle is equipped with the
HomeLink
complies with Part 15 of the Federal
Communications Commission Rules in
the U.S. and the RSS-210 of Industry
Canada in Canada. Its operation is subject
to the following two conditions:
(1) this device may not cause harmful
interference, and (2) this device must
accept any interference received, includ-
ing interference that may cause undesired
operation.
Changes and modifications to this system
by anyone other than an authorized
service facility could void authorization to
use this equipment.
HomeLink
registered trademarks of Johnson Con-
trols, Inc.
buttons on the
. W h e n p r o g r a m m i n g
HomeLink
tem, you may be operating a
garage door opener or other
device. Make sure that people
Wireless Control System, it
®
and the HomeLink house are
® ®
WARNING
t h e
Wireless Control Sys-
®
and objects are out of the way of
the garage door or other device
to prevent potential harm or
damage.
. Do not use the HomeLink
less Control System with a gar-
age door opener that lacks the
safety stop and reverse feature
as required by applicable safety
standards. A garage door opener
which cannot detect an object,
signaling the door to stop and
reverse, does not meet these
safety standards. Using a garage
door opener without these fea-
tures increases risk of serious
injury or death. For more infor-
mation, consult the HomeLink
website at www.homelink.com or
call 1-800-355-3515.
CAUTION
When programming the HomeLink
Wireless Control System to operate
a garage door opener or an entrance
gate, unplug the device's motor
from the outlet during programming
to prevent motor burnout.
Wire-
®
®
®