Subaru 2011 Impreza Owner's Manual page 283

7-20
Starting and operating
the "AUTO [+]" mode. After setting the
mode, " " on the combination meter
illuminates.
Pull the control switch rearward to select
the "AUTO [−]" mode. After setting the
mode, " " on the combination meter
illuminates.
When the "AUTO [+]" mode is selected,
pull the control switch rearward to change
to the "AUTO" mode. When the "AUTO
[−]" mode is set, push the control switch
forward to change to the "AUTO" mode.
& Manual mode
In the manual mode, you can use the
center differential control switch to adjust
the initial LSD torque as desired. When
this mode is selected, the "AUTO" indica-
tor light on the combination meter turns
off.
! Center differential control switch
and indicator light
The control switch is located beside the
parking brake lever. By pushing the
control switch forward or pulling it rear-
ward, it is possible to change the initial
LSD torque.
The center differential indicator lights on
the combination meter give six levels of
indication. The indicator lights and control
switch are linked; when the switch is
pushed or pulled to change the initial
LSD torque, the illumination position of the
indicator lights changes accordingly.