Subaru 2011 Impreza Owner's Manual page 168

1) HomeLink button 1
®
2) HomeLink button 2
®
3) HomeLink button 3
®
2. Press and hold the two outer
HomeLink buttons (button 1 and button
®
3) until the HomeLink indicator light
®
begins to flash (after approximately 20
seconds). Then release both buttons.
3. Hold the end of the entrance gate's/
garage door opener's hand-held transmit-
ter between 1 and 3 inches (25 and 76
mm) away from the HomeLink
wish to program.
4. Press and hold the desired HomeLink
button.
5. Press and release ("cycle") the hand-
held transmitter button every 2 seconds
until step 6 is complete.
6. When the indicator light flashes slowly
and then rapidly after several seconds,
release both buttons.
7. Plug the motor of the entrance gate/
garage door opener to the outlet.
8. Test your entrance gate/garage door
opener by pressing the programmed
HomeLink button.
®
! Operating the HomeLink
Control System
Once programmed, the HomeLink
less Control System can be used to
remote-control the devices to which its
buttons are programmed. To activate a
device, simply press the appropriate but-
ton. The indicator light illuminates, indicat-
ing that the signal is being transmitted.
! Programming other devices
To program other devices such as door
locks, home lighting and security systems,
contact HomeLink
or call 1-800-355-3515.
button you
! Reprogramming a single HomeLink
®
button
®
1. Press and hold the HomeLink
you wish to reprogram. DO NOT release
the button until step 4 has been com-
pleted.
2. When the HomeLink
begins to flash slowly (after approximately
20 seconds), position the hand-held trans-
mitter of the device between 1 to 3 inches
(25 to 76 mm) away from the HomeLink
button you wish to program.
3. Press and hold the hand-held trans-
mitter button. The HomeLink
light will flash, first slowly and then rapidly.
4. When the indicator light begins to flash
rapidly, release both buttons.
Wireless
®
The programming for the previous device
Wire-
is now erased and the new device can be
®
operated by pressing the HomeLink
button.
! Erasing HomeLink
NOTE
. Performing this procedure erases
the memory of all the preprogrammed
buttons simultaneously. The memory
of individual buttons cannot be erased.
at www.homelink.com . It is recommended that upon the
®
sale of the vehicle, the memory of all
programmed HomeLink
®
erased for security purposes.
button
®
indicator light
®
3-47
Instruments and controls
indicator
®
button memory
®
buttons be
®
– CONTINUED –
®
®