Delete An Access Pin; Delete All Access Pins; Enable/Disable Partymode - Ghost Controls AXWK Manual

DELETE AN ACCESS PIN:

A. Press and Release PROGRAM BUTTON
(the PartyMode, 1-Key, Vacation LEDs comes on)
B. Enter your Primary Pin
C. Press and Release PROGRAM BUTTON
D. Enter 3 2
E. Press and Release PROGRAM BUTTON
F. Enter ACCESS PIN to be DELETED
G. Press and Release PROGRAM BUTTON

DELETE ALL ACCESS PINS:

the gate)
A. Press and Release PROGRAM BUTTON
(the PartyMode, 1-Key, Vacation LEDs comes on)
B. Enter your Primary Pin
C. Press and Release PROGRAM BUTTON
D. Enter 3 3
E. Press and Release PROGRAM BUTTON

ENABLE/DISABLE PARTYMODE:

The gate will stay open and autoclose (if enabled) is suspended. The gate opener will BEEP TWICE if
PartyMode Enable:
attempting to close the gate while PartyMode is enabled.
NOTE: IF THE ABOVE DOES NOT DISABLE PARTYMODE TURN THE GATE OPENER OFF AT CONTROL BOX AND
THEN BACK ON AND THIS WILL EXIT PARTYMODE.
A. Press and Release PARTY BUTTON
B. Enter your Primary Pin
C. Press SEND
Repeat the above steps to disable PartyMode.
PartyMode.
© G h o s t C o n t r o l s 2 0 2 0
6
(deleted pin will no longer operate the gate)
(ALL access pins are deleted, Primary Pin is only one able to operate
(this holds your gate open)
The gate opener will BEEP THREE (3) TIMES to indicate that it is exiting
3 2
3 3