Installing The Batteries (Need 2 C Batteries); Programming Your Primary Pin - Ghost Controls AXWK Manual

IMPORTANT MUST READ BEFORE PROGRAMMING
Make sure you have a Ghost Controls transmitter that is already programmed to operate the gate.
■
You MUST CREATE a NEW PRIMARY PIN other than the factory default of '0000' in order to use the keypad.
■
ALL LEDs including the backlight LEDs must be OFF (Sleep mode) prior to enter any of the programming mode.
■
AUDIBLE INDICATORS
Long beep (2-3 seconds) followed by 2 short beeps = PROGRAMING ERROR
■
3 long beeps, pause, then 2 short beeps = PROGRAMING SUCCESSFUL
■
2 beeps then turn OFF all LEDs = Unit is going into sleep mode due to inactivity.
■
PROGRAMMING THE KEYPAD FOR THE 1
A. INSTALLING THE BATTERIES: Use only C-Size Alkaline Batteries (2 needed). Energizer or Duracell recommended.
B. PROGRAMMING YOUR NEW PRIMARY PIN: (DO NOT GIVE OUT PRIMARY PIN FOR ACCESS)
PRIMARY PIN is needed to operate Partymode, 1-Key and Vacation Modes.
A. Press and Release PROGRAM BUTTON
(the PartyMode, 1-Key, Vacation LEDs come on)
B. Enter 0 0 0 0
C. Press and Release PROGRAM BUTTON
D. Enter 7 6
E. Press and Release PROGRAM BUTTON
F. Enter NEW 4 DIGIT PRIMARY PIN
YOU CAN NOT USE 0 0 0 0
G. Press and Release PROGRAM BUTTON
© G h o s t C o n t r o l s 2 0 2 0
2
TIME:
ST
0 0 0 0
7 6
C BATTERY
C BATTERY