System Maintenance - Subaru 2008 Impreza Owner's Manual

feature programming can be adjusted
using the following procedure.
1. Open the driver's door (the driver's
door must remain opened throughout the
entire process).
2. Insert the key into the vehicle's ignition
switch and turn to the "ON" position.
3. Locate the small black programming
button behind the fuse box cover, on the
driver's side left under the dashboard
panel.
4. Press and hold the black programming
button for 10 to 15 seconds. The horn will
honk and the turn signal lights will flash
three times to indicate that the system has
entered programming mode. At this point
you can proceed to either step 5 or step 6.
5. To program a remote transmitter:
press and release the " " button on each
transmitter. The horn will honk and the
turn signal lights will flash one time to
indicate a successful transmitter learn
each time the " " button is pressed. You
can program up to eight transmitters.
6. To toggle the Horn Confirmation chirps
ON/OFF: press and release the brake to
toggle the feature. The horn will chirp and
the turn signal lights will flash one time to
indicate Confirmation Horn Chirps are
"OFF". The horn will honk and the turn
signal lights will flash 2 times to indicate
Confirmation Horn Chirps are "ON".
Pressing the brake pedal repeatedly will
toggle the feature ON or OFF each time.
7. To exit the remote transmitter and
feature programming mode, turn the igni-
tion switch to the "LOCK" position, remove
the key from the ignition switch and test
operation of the remote transmitter(s) and
horn confirmation feature.
& System maintenance
! Changing the remote control bat-
teries
The two 3-volt lithium batteries (model
CR-1220) supplied in your remote control
should last approximately three years,
depending on usage. When the batteries
begin to weaken, you will notice a
decrease in range (distance from the
vehicle that your remote control operates).
Follow the instructions below to change
the remote control batteries.
Starting and operating
1. Carefully pry the remote control halves
apart using a small flat-head screwdriver.
– CONTINUED –
7-13