Keyless Access With Push-Button Start; System Maintenance - Subaru Crosstrek 2016 Owner's Manual

7-20
Starting and operating/Remote engine start system (dealer option)
ing to the following procedure.
1. Open the driver s door (the driver s
door must remain opened throughout the
entire process).
2. Depress and hold the brake pedal.
3. Turn the ignition switch to ON then
LOCK / OFF , back to ON then LOCK /
OFF , back to ON then LOCK / OFF ,
then back to ON again and leave the
ignition ON throughout the programming
process.
4. The system will flash the side marker
lights, tail lights and parking lights and
honk the horn three times, indicating that
the system has entered the transmitter
learn mode.
5. Press and release the
the transmitter that you want to program.
6. The system will flash the side marker
lights, tail lights and parking lights and
honk the horn one time, indicating that the
system has learned the transmitter. Upon
successful programming, the remote start
confirmation transmitter button will flash
one time.
7. Repeat step 5 for any additional
transmitters (the system will accept up to
eight transmitters).
8. The system will exit the transmitter
learn mode if the key is turned to the
LOCK / OFF position, the door is closed
or after 2 minutes.

System maintenance

NOTE
For models without
with push-button start system :
In the event that the vehicle s battery is
replaced, discharged or disconnected,
it will be necessary to start the vehicle
a minimum of one time using the key
prior to activating the remote engine
start system. This is required to allow
the vehicle electronic systems to re-
synchronize.
Changing the batteries
button on
. Do not let dust, oil or water get on
or in the remote engine start
transmitter when replacing the
battery.
. Be careful not to damage the
printed circuit board in the re-
mote engine start transmitter
when replacing the battery.
. Be careful not to allow children to
touch the battery and any re-
moved parts; children could
swallow them.
keyless access
For models with keyless access with
push-button start system :
Perform the procedure described in Re-
placing battery of access key
For models without
with push-button start system :
The two 3-volt lithium batteries (model
CR-2032) supplied in your remote engine
CAUTION
start transmitter should last approximately
one year, depending on usage. When the
batteries begin to weaken, you will notice
a decrease in range (distance from the
vehicle that your remote control operates).
Follow the instructions below to change
the remote engine start transmitter bat-
teries.
. There is a danger of explosion if
an incorrect replacement battery
is used. Replace only with the
same or equivalent type of bat-
tery.
. Batteries should not be exposed
to excessive heat such as sun-
shine, fire or the like.
keyless access
11-44.