Heater Operation - Subaru 2008 Impreza Owner's Manual

WARNING
Continued operation with the air
inlet selection button in the ON
position may fog up the windows.
Switch to the OFF position as soon
as the outside dusty condition
clears.
& Heater operation
! Defrosting or defogging the wind-
shield
To direct warm air to the windshield and
front door windows:
1. Set the air flow control dial to the "
position.
2. Turn the temperature control dial all
the way to the right.
3. Set the fan speed control dial to the
highest speed.
If your vehicle is equipped with an air
conditioner, when the "
is selected, the air conditioner compressor
automatically operates regardless of the
position of the air conditioner button to
defog the windshield quickly.
However, the air conditioner indicator light
does not illuminate at this time.
NOTE
Warm air also comes out from the right
and left air outlets. To stop warm air
flow from these outlets, turn the corre-
sponding thumb-wheel down.
"
! Heating and defrosting
" or " " position
To direct warm air toward the floor and the
windshield:
1. Set the air flow control dial to the " "
position.
2. Set the temperature control dial to the
most comfortable level.
3. Set the fan speed control dial to the
desired speed.
If your vehicle is equipped with an air
conditioner, when the "
is selected, the air conditioner compressor
automatically operates regardless of the
position of the air conditioner button to
defog the windshield quickly.
However, the air conditioner indicator light
does not illuminate at this time.
4-5
Climate control
" or " " position
– CONTINUED –