State Emission Testing (U.s. Only) - Subaru 2000 Legacy Owner's Manual

3. Stop filling the tank after the fuel filler pump automatically clicks off.
Do not add any more fuel.
4. Put the cap back on, turn it clockwise until you hear a clicking
noise. Be certain not to catch the tether under the cap while tighten-
ing.
5. Close the fuel filler lid completely.
If you spill any fuel on the painted surface, rinse it off immediately.
Otherwise, the painted surface could be damaged.
NOTE
If the fuel filler cap is not tightened until it clicks or if the tether is
caught under the cap, the CHECK ENGINE warning light may
come on. Refer to the "Warning and indicator lights" section lo-
cated in chapter 3.

State emission testing (U.S. only)

WARNING
Testing of an All-Wheel Drive vehicle must NEVER be performed
on a single two-wheel dynamometer. Attempting to do so will
result in uncontrolled vehicle movement and may cause an acci-
dent or injuries to persons nearby.
CAUTION
Resultant vehicle damage due to improper testing is not covered
under the SUBARU Limited Warranty and is the responsibility of
the state inspection program or its contractors or licensees.
At state inspection time, remember to tell your inspection or service
station in advance not to place your Subaru AWD vehicle on a two-
wheel dynamometer. Otherwise, serious transmission damage will
result.
Some states have started using dynamometers in their state inspection
programs in order to meet their obligation under federal law to implement
7-6