Subaru 1998 Legacy Owner's Manual page 174

imum and right side minimum, BAL. 0 for neutral, BAL. R9 for left side
minimum and right side maximum). Choose desired setting by turning
the volume control knob. The control function returns to volume con-
trol mode after about 5 seconds.
J FM/AM selection button (FM AM)
Push the FM/AM selection button when the radio is on to select FM1,
FM2 or AM reception. Each time this button is pressed, the band will
change in the following order:
FM1
The display indicates which is currently selected.
J Stereo indicator
The stereo indicator "ST" will come on when an FM stereo broadcast is
received.
J Manual tuning (TUNE)
Press the "TUNE" button marked "Y" to increase the tuning frequency
and press the "TUNE" button marked "B" to decrease it.
Each time the button is pressed, the frequency changes 10 KHz in the
AM waveband and 0.2 MHz in the FM waveband.
Constant pressure on the button causes a continuous change in the fre-
quency.
J Automatic tuning (SCAN)
Press the "SCAN" button to change the radio to the SCAN mode. In this
mode, the radio scans through the radio band until a station is found.
The radio will stop at the station for five seconds while displaying the fre-
quency, after which scanning will continue until the entire band has been
scanned from the low end to the high end.
Press the "SCAN" button again to cancel the SCAN mode and to stop on
any displayed frequency.
5-22
FM2 AM